Bolt - Old Style Centa Plate

OBSOLETE and DISCONTINUED

Fastener bolt used to affix centa plate drive plate to flywheel (old style round plate). This is a specialty fastener that is only available for replacement use where applicable, and is nearly an obsolete part.

This fastener version is 1 of 3 possible variants that were the result of the evolution of the engine design throughout the years and the starter drive change when components from the original starter designs changed. Reference the 2340150 starter product page to learn more about identifying starter designs. The last picture on this product page displays the 3 variants of drive plate bolt used.

2325800 is a standard drive plate bolt used primarily on star-shaped Centa drive plates.

2325801 is a modified drive plate bolt used to secure 4-stage plate to flywheel to get full engagement

2325802 is a modified drive plate bolt used with round Centa drive plates and 2nd gen starter on up.

Important take-away from this. Because of the generations of starters used this affects what bolt has to be on the drive and what the starter relationship is. Because the 2nd generation starter could either have the correct drive in it or a replacement drive without necessary clearance, caution must be taken. Because we cannot really advice what combination should work, it would be recommended to use the latest gear reductions starter 2340150 which has no clearance problems with any bolt combination. With current gear reduction 2340150 starter the 2325800 fastener could be used with all drive plate combinations, adding a washer part number 2338418 would enable use with 4-stage plate as well.